Go to hazelcast.org/documentation

Configuring Hazelcast

When Hazelcast starts up, it checks for the configuration as follows:

  • First, it looks for the hazelcast.config system property. If it is set, its value is used as the path. This is useful if you want to be able to change your Hazelcast configuration: you can do this because it is not embedded within the application. You can set the config option with the following command:

    - Dhazelcast.config=<path to the hazelcast.xml>.

    The path can be a normal one or a classpath reference with the prefix CLASSPATH.

  • If the above system property is not set, Hazelcast then checks whether there is a hazelcast.xml file in the working directory.
  • If not, then it checks whether hazelcast.xml exists on the classpath.
  • If none of the above works, Hazelcast loads the default configuration, i.e. hazelcast-default.xml that comes with hazelcast.jar.

When you download and unzip hazelcast-<version>.zip you will see a hazelcast.xml in the /bin folder. This is the configuration XML file for Hazelcast. Part of this configuration XML is shown below.

For most users, default configuration should be fine. If not, you can tailor this XML file according to your needs by adding/removing/modifying properties (Declarative Configuration). Please refer to the Configuration Properties section for details.

Besides declarative configuration, you can configure your cluster programmatically (Programmatic Configuration). Just instantiate a Config object and add/remove/modify properties.

You can also use wildcards while configuring Hazelcast. Please refer to the Using Wildcard section for details.



RELATED INFORMATION

Please refer to the Hazelcast Configuration chapter for more information.