Documentation Version: 3.5 - Publication Date : Jun 17, 2015

Using Variables

In your Hazelcast and/or Hazelcast Client declarative configuration, you can use variables to set the values of the elements. This is valid when you set a system property programmatically or you use the command line interface. You can use a variable in the declarative configuration to access the values of the system properties you set.

For example, see the following command that sets two system properties.

-Dgroup.name=dev -Dgroup.password=somepassword

Let's get the values of these system properties in the declarative configuration of Hazelcast, as shown below.

<hazelcast>
  <group>
    <name>${group.name}</name>
    <password>${group.password}</password>
  </group>
</hazelcast>

This also applies to the declarative configuration of Hazelcast Client, as shown below.

<hazelcast-client>
  <group>
    <name>${group.name}</name>
    <password>${group.password}</password>
  </group>
</hazelcast-client>

If you do not want to rely on the system properties, you can use the XmlConfigBuilder and explicitly set a Properties instance, as shown below.

Properties properties = new Properties();

// fill the properties, e.g. from database/LDAP, etc.

XmlConfigBuilder builder = new XmlConfigBuilder();
builder.setProperties(properties)
Config config = builder.build();
HazelcastInstance hz = Hazelcast.newHazelcastInstance(config);